Ghost Saddle Pads - long flap

These stirrup straps are thin, yet very strong. Made from granite biothane, they'll hold up longer than leather but don't create a bump under your leg. Even better when you run the buckle at the bottom and use the handy keeper to put the excess strap neatly out of the way.
The standard configuration Ghost stirrup straps are 1" granite biothane and can work with any stirrup style. These are the only Ghost stirrup straps that work with the English slip-on fenders.
If you prefer a webber style strap, check out the T-bar and Conway Straps.

Ghost now has several options for girth/cinch rigging. The original sliding V is great as it allows the rider to independently position the girth and saddle and the sliding V will move with the horse through all gaits. Any saddle may be ordered with cinch rigging, either nylon or leather covered nylon (some have commented the leather covered doesn't slide as well as the nylon). And now we've added the option for the Cavallin/Puro rigging for all saddles as well. This rigging is simple and in some cases more stable since it can't move as easily with the horse, but the rider can adjust the girth position by tightening one billet more than the other to create the desired angle.
Here's a great video on using the western cinch rigging - https://www.youtube.com/watch?v=RzkIWioQAXo

Can affect the rider's pelvis tilt, refines the twist, and slightly deepens the seat. It goes under the front of the seat, with the wide side toward the pommel and the pointy side toward the rider. It can be moved forward/back for a greater effect.
Riders who have a low pelvic floor may not like the bolster. For those who are looking at the product to tilt the pelvis, one of the other rider balancing aids will have a great effect without discomfort.
To install, release the velcro under the front center of the seat, then tug the seat back over the front dees. Place the bolster and press the seat back into position, making sure all is still symmetrical. Replace the front velcro tab and push the seat back over the front dees. This last part can be difficult, especially when the saddle is new - to make it easier, pull some twine or a shoelace through the dee to give you more leverage.

For those who prefer a Webber style stirrup strap, Ghost has designed a T-bar stirrup strap. The top has a nylon loop that goes through the stirrup ring and there's a leather cover for the T-bar.
The hole in your stirrup needs to be 30mm x 10mm (1.25" x 0.25") minimum for the T-bar to fit through. Not recommended for jumping or hard use like endurance as the T has sharp edges and can wear the biothane for some riders - it's always important to check your strap holes for any type of strap or buckle! Check this video - https://www.youtube.com/watch?v=eEKSsCCZ9KA.
Note: due to a worldwide shortage in T-bars, Ghost changed from the T-bar to a Conway and we found the Conway option to be superior in a couple ways. First it works with all stirrup styles and second, the overall strength of the setup is better for harder use riding. I still have T-bars, but personally prefer the Conways.